SEALBOND 215-B

SEALBOND CONCRETE EPOXY ADHESIVE (215-B) is a two component adhesive system specially formulated for structural concrete application and bonding of old to new concrete. It has a low to medium viscosity. When compounded, the admixture produces a strong bond with minimum shrinkage and flexibility properties. It contains a special polymeric curing agent that provides the film with a high degree of toughness, adhesion and chemical corrosion resistance.

APPLICATION

SEALBOND 215-B is highly recommended for the following:

• Bonding new to old concrete
• Repair of cracked concrete structure including earthquake damages
• Sealing concrete pavement and structure against intrusion of water
• dowelling
• Bonding non-slip aggregates on concrete surfaces
• Securing overlays on concrete surfaces
• General purpose adhesive

SURFACES PREPARATION AND APPLICATION PROCEDURE

1. Clean surface from debris, oil, grease, dirt and other foreign materials either by mechanical method or chemical process.
2. Mix 2 parts by volume of resin base to 1 part by volume of hardener. Mix only enough quantities that can be used within the pot-life of the mixture.
3. Apply SEALBOND EPOXY 215-B at the rate of 6 to 8 sq. meters per gallon depending on the thickness of deposit or porosity of the substrate.
4. Pour fresh concrete while SEALBOND EPOXY 215-B is still wet or tacky.
5. Use brush with stiff bristles to fill up concrete voids and concrete crevices with Epoxy industrial Adhesive.
6. Clean up. All tools and equipment must be cleaned immediately after application. Use Sealbond Epoxy Reducer to remove excess resin and hardener.

PRECAUTION

Wear rubber or plastic gloves to avoid contact with skin. Use soap and water to remove the mixture from hands. Do not use strong solvents to remove mixture from skin.